Skip to content
Cleaning of Rowenta ironing centers with removable tank (Rowenta ironing centers with unlimited autonomy with autofill)
This tutorial is valid for Rowenta ironing centers of this type.
How to clean Rowenta ironing centers
Due to the continued use of the iron with water, dirt can accumulate. When a excess dirt and limescale In the boiler of the ironing center, the iron seems to be rusting due to the resistance, although in reality, what we see is a problem of mud. To begin with, it is important to prevent these problems:
- Do not use distilled or flavored water.
- Pass the tap water through a filter jug British, BWT...
But sooner or later the accumulation of dirt ends up taking place. In these cases, it is best to clean the different parts of the ironing center.
Steps to clean side access plates
Follow these steps to clean your Rowenta iron with side boiler access:
1. remove deposit and the side cap. Here we will have access to the caldera.
2. rod cleaning scale deposit (if they have it, some Rowenta irons only have a side cap on the boiler). The rod is normally cleaned with water and a scouring pad.
3. Empty the boiler from the side of the apparatus. Here you will begin to see the first impurities coming out of the interior of the appliance.
 |
| Rowenta cleaning accessory |
4. with him special cleaning accessory for Rowenta irons connected to the boiler and a pressurized water tap, we fit one mouth on the tap and another on the boiler of the Rowenta iron. When you open the tap and introduce the pressurized water into the boiler, the interior will be cleaned. Rinse the boiler of the iron until it is empty by shaking the boiler. WE ALREADY HAVE THE PART OF THE CLEAN BOILER!
But traces of dirt remain in the boiler outlet tubes and on the soleplate of the iron. So we are going to carry out a second part of the cleaning. For it...
5. We put the iron thermostat to half approximately of temperature, so that the resistance remains warm. You have to start throwing steam through the iron (at first it will take time because the boiler is completely empty). This first steam will continue dragging remains of mud.
6. We put the iron upside down to help the remains of dirt to come out, under the tap while intermittently pressing the button steam. Little by little the dirt will come out and it will be less and less inside the device.
7. Be careful before using the iron!,.com Even at the beginning of the next use, it may still give off some dirty steam, test the iron on a useless cloth to make sure everything works perfectly.
You can see a video tutorial following this link of our youtube channel.